Sedan/Coupe Installation

Route cable around windshield

Feed the antenna cable underneath the rubber molding around the rear window. Use a plastic putty knife or similar object to lift the rubber molding around the rear window and tuck the antenna cable underneath.

Route the antenna cable around and down the window to the lowest point.

If your rear window does not have rubber molding, SiriusXM recommends consulting with a professional installer.

Route cable out of window molding and into weather stripping around trunk opening

Route the antenna cable out of the window molding and into the rubber weather stripping around the trunk opening.

Lift the weather stripping from the opening and tuck the cable inside it. Then replace the weather stripping. To avoid sharp bends in the cable, run the cable inside of the weather stripping for a few inches.

Then remove the cable from the weather stripping inside of the trunk. Keep the cable away from hinges, gears or anything else that could damage it.

Route cable along trunk wall and into cabin

Route the cable out from the rubber weather stripping and along the trunk wall. Continue routing the cable into the cabin through a conduit or along an existing wiring harness.

Bring cable out from trim and route under carpet to dashboard or console

Bring the cable out from under the trim near the dashboard and route it under the carpet toward the dashboard or console. Coil any excess cable in a hidden location, such as under the carpet, keeping it away from any vehicle pedals or controls. Secure the excess cable with cable tidies or wire ties.

Bring the end of the cable out at the SiriusXM Radio location. Leave yourself enough cable so you can easily connect it to the antenna connector (sometimes marked ANT) of the SiriusXM Radio or Vehicle Dock.

Route cable around windshield

Feed the antenna cable underneath the rubber molding around the rear window. Use a plastic putty knife or similar object to lift the rubber molding around the rear window and tuck the antenna cable underneath.

Route the antenna cable around and down the window to the lowest point.

If your rear window does not have rubber molding, SiriusXM recommends consulting with a professional installer.